مدار مجتمع (آی سی) آی‌سی واسط ارتباطی درایور، گیرنده و فرستنده‌گیرنده‌

Product Attributes

Introduction

BIN1021-C is a Local Interconnect Network (LIN) transceiver. LIN is a low-speed UART communication protocol supporting automotive in-vehicle networks. The BIN1021-C controls the LIN bus state via the TXD pin with optimized slew rate and waveform shaping to minimize EME, and reports bus status through its open-drain RXD output pin. The BIN1021-C supports 12V applications through a wide input voltage range, along with a low-power sleep mode. The device supports wake-up from the LIN, WAKE_N, and SLP_N pins. Through the INH pin, the device can selectively enable various power supplies present at the node, thereby reducing battery current consumption at the system level. The BIN1021-C integrates resistors for slave node applications and ESD protection, reducing the number of external components in system applications. In the event of ground drift or supply voltage disconnection, the device prevents reverse current from flowing through LIN to the supply input. The BIN1021 is an interface device between a LIN protocol controller and the physical bus, suitable for trucks, buses, passenger vehicles, and industrial control applications, with a data transfer rate of up to 20kbps. The BIN1021 receives the transmit data stream from the protocol controller at the TXD input and converts it into bus signals with optimized slew rate and waveform shaping; input data on the LIN bus is output to an external MCU via the receiver's RXD port. This device is compatible with the LIN 2.x/ISO 17987-4:2016/SAE J2602 standard. The LIN bus features output short-circuit protection, and when overheating occurs, the internal over-temperature protection circuit sets the bus to a high-impedance state.

Features

• AEC-Q100 qualified for automotive applications
• Compliant with LIN 2.0, LIN 2.1, LIN 2.2, LIN 2.2A, and ISO 17987-4:2016 (12V) Electrical Physical Layer (EPL) specifications
• Compliant with SAE J2602-1 LIN network standard for vehicle applications and SAE J2602-2 LIN network conformance testing for vehicle applications
• Supports 12V applications
• Wide operating input voltage range: VBAT from 5.5V to 27V
• LIN data transfer rate up to 20kbps
• Operating modes: Normal mode; Low-power standby mode; Low-power sleep mode
• Low-power mode wake-up support: Remote wake-up via LIN bus, local wake-up via WAKE_N pin, direct wake-up via SLP_N pin
• Supports 3.3V and 5V input logic levels
• Integrated 30kΩ LIN pull-up resistor
• System-level power consumption control via INH pin
• Unpowered/power-down glitch-free operation on LIN bus and RXD output
• Protection features: ±58V LIN bus fault tolerance, 42V load dump support, IEC ESD protection, undervoltage protection on VBAT input, TXD dominant state timeout, thermal shutdown, unpowered node or ground disconnection failure protection at system level
• Junction temperature range: -40°C to 150°C
• Available in SOIC(8) and leadless DFN(8) packages (3.0mm×3.0mm)

Applications

• Body electronics and lighting
• Infotainment systems and instrument clusters
• Hybrid electric vehicles and powertrain systems
• Passive safety
• Electrical appliances