آر اف (فرکانس رادیویی) و بی‌سیم ماژول‌ فرستنده‌گیرنده و مودم آر اف

Product Attributes

Introduction

The WiFi module DT-LIGHT is manufactured by using a high-performance chip named ESP8266. This small chip is encapsulated an enhanced Tensilica’s L106 diamond series 32-bit kennel CPU with a SRAM. Thus, ESP8266 has the complete function Wi-Fi function; it can be applied independently, and also can be used as a slaver working with other host CPU. When ESP8266 is applied as a slaver, it can start from the onboard flash. The built-in high-speed buffer is not only benefit to improve the system performance, but optimize the store system. In addition, DT-LIGHT WiFi module can be used as Wi-Fi adapter by SPI/SDIO or I2C/UART interface, when it is applied to other MCU design. The DT-LIGHT WiFi module supports the standard IEEE802.11 b/g/n/e/i protocol and the complete TCP/IP protocol stack. User can use it to add the WiFi function for the installed devices, and also can be viewed as an independent network controller. Anyway, DT-LIGHT module provides many probabilities with the best price.

Features

• Built-in Tensilica L106 ultra-low power consumption 32-bit MCU, the main frequency can be 80MHz and 160MHz, also support RTOS
• Built-in TCP/IP protocol stack
• Built-in 1 channel 10-bit high precision ADC
• Interfaces include HSPI, UART, I2C, I2S, IR Remote Control, PWM, GPIO
• 20uA deep-sleep current, less than 10uA cutoff current
• 2ms wake-up time
• 1.0mW consume power (DTIM3 and standby state)
• Support 802.11 b/g/n/e/i
• Support three modes: Station, SoftAP, and SoftAP + STA
• Support Wi-Fi Direct (P2P)
• Support hardware acceleration for CCMP (CBC-MAC, computation mode), TKIP (MIC, RC4), WAPI(SMS4), WEP(RC4), CRC
• P2P detection, P2P GO mode/GC mode and P2P power management
• WPA/PA2 PSK and WPS
• Support 802.11 i security: pre-certification and TSN
• Support 802.11n (2.4 GHz)
• 802.1h/RFC1042 frame encapsulation
• Support seamless roam
• Support AT remote upgrade and cloud OTA upgrade
• Support Smart config function for Android and iOS device
• 1 x UART
• 5 x PWM
• 1 x EN
• Internal 2M SPI Flash
• Module size: 15mm×20mm×3mm

Applications

• Serial transparent transmission
• WiFi prober
• Smart power plug/Smart LED light
• Mesh networks
• Sensor networks
• Wireless location recognition
• Wireless location system beacon
• Industrial wireless control