ایزولاتور ایزولاتور دیجیتال

Product Attributes

Introduction

The ISO35T is an isolated differential line transceiver with an integrated oscillator output for supplying primary-side voltage to an isolation transformer. This device is a full-duplex differential line transceiver for RS-485 and RS-422 applications, and can be easily configured for half-duplex operation (simply connect pin 11 to pin 14, and pin 12 to pin 13).

These devices are well suited for long transmission lines, where ground loops are broken to provide a significantly wider common-mode voltage range. The device's symmetrical isolation barrier has been tested to provide VDE-compliant 4242V_PK isolation for up to 60 seconds between the bus transceiver and the logic-level interface.

All wired I/O are susceptible to electrical transient noise from various sources. If these transients have sufficient amplitude and duration, they can potentially damage the transceiver and/or nearby sensitive circuitry. The ISO35T significantly reduces the risk of data corruption and costly control circuit damage.

The ISO35T is rated for an operating temperature range of -40℃ to 85℃.

Features

• Designed for RS-485 and RS-422 applications
• Signal transmission rate up to 1Mbps
• 1/8 unit load, up to 256 nodes on a single bus
• Thermal shutdown protection
• Typical efficiency >60% (I_LOAD = 100mA)
• Low driver bus capacitance: 16pF (typical)
• Failsafe receiver for open, short, and idle bus conditions
• Logic inputs withstand 5V
• 50kV/μs transient immunity, typical
• Bus pin ESD protection
• 16kV HBM between bus pins and GND2
• 6kV HBM between bus pins and GND1
• Safety and regulatory approvals
• 4242V_PK basic insulation per DIN EN IEC60747-17 (VDE0884-17)
• 2500V RMS isolation for 1 minute per UL1577
• CSA Component Acceptance Notice 5A, IEC60950-1 and IEC61010-1

Applications

• Isolated RS-485/RS-422 interface
• Factory automation
• Motor/motion control
• HVAC and building automation networks
• Networked Security Stations